Fiat 500 Replacement Key Fob
It might be time to change the battery if your 500 remote key fob isn't working. If you replace the battery, but it's still not working the issue could be somewhere else.
At United Locksmith, we specialize in making new keys for old cars. We have the tools and parts required for this type of service.
Dead Coin Battery
A dead battery is the main cause of your
fiat key fob replacement 500 keyfob not locking or unlocking the doors. The battery inside the key fob is likely to drain quickly when you don't use it often enough. If your remote is beginning to show signs like a loss in range or stopped functioning in the middle of the night, then your battery may be dead.
The battery in the key fob is held in place by metal clips that hold it in place. If the clips aren't secure, they can cause contact issues that will stop the remote from receiving power. Utilizing a small screwdriver, pull the clip that holds the retaining pin open to take out the battery and insert a new one. Choose a battery that is the same voltage, size and specifications as the original.
The exposure to water can cause the key fob to become corroded or damaged. Even a quick bath in warm, soapy water could cause damage to the chip. Make sure your key fob is dry.
Water Damage
If your key fob isn't working correctly, it could be due to water damage. The rubber seals on key fobs keep them from being damaged by a light drizzle or splash of water. However, it's important to keep the car keys away from the ocean, washing machine,
Fiat Key Fobs and even the pool.
The key fob has an electronic chip which sends an electronic message to the immobilizer system of your car. The chip is what allows the 500 to lock and start. If it gets wet it won't function.
You can clean the inside electronics of your keyfob with isopropyl Alcohol or an electronic cleaner to see whether they're still functioning. It is recommended to replace a key fob if it's submerged into salt water rather than try to fix it yourself.
A replacement fob might cost you a little bit however it's much less expensive than paying to have your Fiat 500 towed to a dealer and fixed there! You can also make it yourself by following a few simple steps. Make sure you have the correct battery type before you attempt to open your keyfob. This is a job that's far simpler than it appears and you can find step-bystep instructions on the internet for nearly any key fob for cars.
Faulty Chip
The chip inside the key fob connects directly with the immobiliser of your vehicle to ensure that the vehicle will only start when right keys are in place. If the chip is damaged or corrupted the car will not start, no matter what you do.
Water damage or a dead cell battery are the two most common reasons for an unreliable chip. Whatever the reason, it is a good idea to leave this work to a locksmith who will be able to repair the chip for you swiftly and at an affordable price.
If your key fob ceases to function after exposure to clean tap water or rain, remove the battery and clean the electronic component with a towel to ensure that it is completely dry before putting it back in. If the key fob will not work, there is the possibility that it's a fried component and needs to be replaced.
Some people go to their dealer if they need an entirely new Fiat fob. But, this can be expensive. If you're looking for a low-cost solution to have your Fiat key fob fixed, look no further than United Locksmith. We have the tools and experience needed to repair your Fiat fob quickly and professionally. way.
Faulty Receiver Module
fiat Key Fobs (
1.179.200.226) send an electronic signal to the vehicle, which will unlock and close doors (and start the car for vehicles with an automatic transmission) up to 50 feet. There are several reasons why the fob could not function. This could be due to a dead coin battery, water damage buttons, worn out buttons, a receiver module issue or signal interference, or a malfunctioning electronic chip.
If the fob was in a pocket which has experienced extreme trauma, like falling on hard floor or being washed in a washing machine or
Fiat key fobs dishwasher, it might not be capable of communicating with the car's Body Control Module (BCM). This is because the BCM is secured and will only accept a signal from a genuine key and not another.
If this is the case, you must replace your fob. A professional locksmith can take care of every aspect of the replacement process as well as programming a new one for the 500. They can even provide you with an clone fob that performs just like the original (and costs only less than what it would cost).